Masterguard Ups Software For Windows
Did you try this: Unplug everything for 30 seconds, to give time for circuits to fall to zero? Then hook it all back up.Just to make sure: Did you plug the load into UPS, and plug UPS into mains? So that the load is powered by mains? Did you then disconnect mains?
I've got Siemens Masterguard A1000 UPS connected via USB to Raspberry Pi with Raspbian. The UPS is listed in lsusb as: Bus 001 Device 008: ID 06da:0002 Phoenixtec Power Co., Ltd UPS I've installed NUT and put the following ups.conf file. MASTERGUARD - UPS - 3000 VA overview and full product specs on CNET.
Normally the UPS should take over at that point.And I supposed you pressed the reset button/switch? Maybe a few buttons in combination?
Masterguard Ups Software For Windows Xp
Software
There may be a combination which resets the UPS, and the manufacturer didn't print it in the instructions.The UPS may be able to detect whether your backup battery has high or low internal resistance. That may be how it determines whether the battery is acceptable. Try testing an alternate battery. Can you connect a car battery (or two if it's a 24 V system) to the internal connections of the UPS? This may not be easy to do. It is likely to have low internal resistance.